Typical up and over style garage door.
Fitting a roller garage door.
A new garage door is a diy project any homeowner can do with a couple of strong friends.
Make sure the roller is in the center of the track.
The roller should smoothly move up and down in the track.
Before removing a heavy roller door from its bracket get a friend to help by supporting the door.
Our trained roller garage door specialist will go through any points to install the door.
You ll also need a ladder and a ratchet tie down strap or rope for extra support.
Lift the garage door so the roller and the length of track you bent are lined up again.
Installing a new garage door to an existing or new garage will almost always require the services of two people.
Once the door is supported mark the position of the door shaft on the right hand door bracket.
After removing the old door installing the new door is done by stacking the door panels one at a time and fitting the roller tracks around the panels wheels.
Please check that the door is the correct size and all component parts are present.
4 manual over ride equipment.
1 box containing door curtain.
Replacing the bottom roller on a garage door can be extremely dangerous when done incorrectly.
If you are installing yourselves diy installation two people will be needed to install the door safely.
Failure to adhere to these warnings may cause the door to cock jamb or fall resulting in property damage and or.
2 two guide rails.
Hit the end of the roller in the hinge with a hammer to push it back into place.
This garage door is heavy and awkward to handle it is recommended that fitting this door is carried out by two people.
With it s simple plug and go system that works on a standard hold to close functionality as standard and easy to follow in depth step by step fitting instructions.
When the door has been delivered to yourselves the door specialist will provide assistance to position the door if assisted fit was chosen.
This is necessary not only for the lifting and manoeuvring of the door but also for the sighting and positioning of the opening mechanism.